Sumo SL001 Manuel d'utilisateur

Sumo RobotsTwo Robot Sumo Wrestlers with Artificial IntelligenceSL001 InstructionsRead and save these instructions.

Remote Control OperationThe remote controls drive two-player (two-player mode) and one player vs. artificial intelligence (one-player mode). Note: Duri

To perform individual commands and preprogrammed maneuvers with the remote control, use the reference chart below. 11Features DescriptionACTION 1 •

ON/OFF • Powers the remote control on and off. ATTACK 1 • Protective Shell — Repels opponent away with the Dohyo barrier. No directional limitatio

Commands and Maneuvers13

Five LEDs on the front of each robot indicate matches played and won. The first to win 3 out of 5 matches wins the game.1. During the first match, the

A full charge yields approximately 5-6 minutes of robot action. A low battery is indicated when the robot’s second and fourth LED blink rapidly. 1.

The Dohyo is a bordered circular area where game matches are played. A match is won or lost when a robot is pushed out of the Dohyo. For best results,

There are three ways to play the game: • Two player (two-player mode) • One player vs. artificial intelligence (one-player mode) • Artificial intelli

1. To select two-player mode, ensure each robot is set to a cor-responding remote control frequency. For example, select R/C1 to control a robot wit

1. To play a game in demonstration mode, slide the switch located on the back of both robots to the A.I. (Artificial Intel-ligence) setting.2. Plac

1. To select one-player mode, ensure one robot is set to a corre-sponding remote-control frequency. For example, select R/C1 to control a robot with

8. To begin the next match, lift up and set down the robots facing each other in the shaded area of the Doyho. Repeat step 5. 9. To start a new ga

Barcode Reader Barcode Reader StandStunt Action Barcode22

Barcode Upload1. Feed the barcode strip through the barcode reader stand, ensuring the paper lays flat and straight in the reader.2. Slide the stri

6. Pull the barcode through the stand, according to arrow direc-tion, at a slow, steady rate, taking no more than five seconds. The robot operates si

Problem Cause SolutionRobot does not respond or responds poorly to remote control.• Infrared signal weak-ened by sunlight or other bright light sour

Robot is slow, erratic or does not move.• Robot batteries are exhausted. • Remote control batter-ies are exhausted.• Remote control power switch

• Clean all parts with a soft, dry cloth.• If not being used, remove the batteries from the remote controls and charging station. SpecificationsPower

Statement of FCC ComplianceWARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the

Statement of FCC Compliance• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect th

Table of ContentsWarnings ...5Important Battery Information ...

WarrantyWhat Is CoveredThis warranty covers any defects in materials or workmanship, with the exceptions stated below.How Long Coverage LastsThis warr

WarningsTroubleshooting ...25Care and Maintenance ...

• Do not expose units to water or moisture.• Do not expose units to extreme temperatures from any source. • Do not drop or subject the units to exc

• Do not mix old and new batteries.• Do not mix Alkaline, standard (Carbon Zinc) or rechargeable (Nickel-Cadmium) batteries.• Use only batteries

Remote Control1. Ensure the power switch is in the OFF position.2. To open the battery compartment on the remote control, remove the screw using a

Note: If remote control battery power is weak, the power LED indicator flashes. Replace the batteries.Charger1. To open the battery compartment on th

OverviewInspired by Sumo wrestling, the goal of the game is to push your robot Sumo opponent out of the Dohyo ring. Players use the infrared remote co